Key Features:
IDAS™ Digital Mode Operation for Trunk
The IC-F1000D/F2000D can
program Type-D single-site trunking and digital
conventional modes as well as analogue mode per channel.
The IDAS digital mode employs 4-level FSK modulation and
the NXDN™ common air interface, offering true 6.25kHz
spectrum efficiency, higher security and better audio
clarity – even at the fringes of the communication
range. The following IDAS features are programmable: •
PTT ID (TX) • Individual/group calls • Radio check (RX)
• Stun/Kill/Revive (RX) • Remote monitor (RX) •
Emergency (TX) • Call alert (RX) • Digital voice
scrambler (15-bit) • Status Call (Power ON/OFF status
and GPS request) • Voting scan for multi-site
conventional operation TX: Transmit, RX: Receive.
Intelligent Emergency Functions on Board
To assist in worker
safety, the IC-F1000D/F2000D has three emergency related
functions: motion detection, man down and lone worker
functions. If one of these functions are activated, the
transceiver automatically enters an emergency phase and
starts counting down to send an emergency signal. The
built-in motion sensor detects position, state of motion
and non-motion.
Optionally GPS Speaker-Microphone
With the optional GPS
speaker-microphone, HM-171GPW, GPS position data can be
attached to a voice or data transmission such as
responding a GPS request status call.
IP67 Waterproof and Dust-tight Protection on this radio
While the
body is compact, the IC-F1000D/F2000D has rugged
construction providing superior protection against water
(1m depth for 30 minutes), dust, sand, mud and other
objects. The radio is also tested to MIL-STD 810
specifications. It can withstand harsh use.
Easy to Hear in a Noisy Environment - great acoustics
The large 36mm
speaker of the transceiver provides clear 800mW* audio.
The built-in BTL amplifier increases the audio output
power and delivers loud and intelligible voice to a
radio operator working in noisy environments. * Typical
with internal speaker.
Built-in 2-Tone and 5-Tone (Analogue mode only)
The
IC-F1000D/F2000D has built-in 2-Tone, 5-Tone, CTCSS and
DTCS signaling capability for analogue mode group
communication and selective calling. The
IC-F1000D/F2000D can be used as an analogue transceiver
ready for future digital migration.
Long-Lasting Battery Pack by Design
The large capacity
waterproof battery pack, BP-280 (2400mAh typ.), provides
18 hours of operating time*. The supplied rapid charger
BC-213* charges the BP-280 in 3.5 hours. * Tx: Rx:
Standby=5:5:90. Power save function ON. BC-213 may be
not supplied depending on version.
Other Features
• DTMF autodial memories available
• MDC
functions: PTT ID, emergency call, radio check (RX) and
stun/revive (RX)
• BIIS PTT ID call
• Surveillance
function included
• Escalating alarm
• VOX capability for
hands-free operation
• Channel announcement function
• Red emergency switch on the top panel
*See PDF download for specifications.